Manifolds and Valves

Ready to use, no threading required. Positive seal. Use with brass or steel fittings. Hardcoat color anodized finish available in black, blue, or red. Other sizes, hole configurations and colors available as special orders. Please call for price and delivery. Automotive tested approval. Tensile 38,000 psi, yield 35,000 psi. Hardened to T6511. Can withstand pH 4.5. Honed ID. Dipped to remove blemishes and chips. Brackets are sold separately.

Composite body is 30% glass filled polyester. Tough and corrosion resistant. Color-coded micrometer and calibrated adjustment knob provide instant reference points. Press red locking ring down to prevent adjustment. Operating temperature is 0 degrees F to 200 degrees F. Operating pressure is 200 psi. max.

An economical replacement to steel manifolds. Nylon manifolds are molded from specialty-blended nylon material that is extremely durable and resistant to impact and corrosion. Used for air, water, lubricants or coolants in various applications. The nylon, with 6% fiberglass fill construction, allows leak free NPT pipe connections. Can be used with steel or brass fittings. Marked in and out and numbered porting for easy installation and identification.

An economical replacement to steel manifolds. Nylon manifolds are molded from specialty-blended nylon material that is extremely durable and resistant to impact and corrosion. Used for air, water, lubricants or coolants in various applications. The nylon, with 6% fiberglass fill construction, allows leak free NPT pipe connections. Can be used with steel or brass fittings. Marked in and out and numbered porting for easy installation and identification.

An economical replacement to steel manifolds. Nylon manifolds are molded from specialty-blended nylon material that is extremely durable and resistant to impact and corrosion. Used for air, water, lubricants or coolants in various applications. The nylon, with 6% fiberglass fill construction, allows leak free NPT pipe connections. Can be used with steel or brass fittings. Marked in and out and numbered porting for easy installation and identification.

High precision multi-stage pressure regulators. Controls output pressure with an accuracy of 0.1%, and very low sensitivity to changes in supply pressure and flow. High degree of regulation and repeatability are achievable by reacting to down stream pressure fluctuations as small as 0.01 psi above set pressure. Movement as small as 0.0001 inches will cause main valve to correct to the proper position. At start up, regulated pressure will return to its output setting, even after long down times. Maximum pressure 150 psi. Temperature rating 20 degrees F to 150 degrees F.

An ideal manual directional control valve for use with all pneumatic systems. Precision lapped rotor and seals offers high tolerance to dirt contamination. Offered as four-way, these valves may be used as two or three-way by plugging unused ports. (Note: "In" port must be used as pressure inlet port to assure efficient operation). Max supply pressure 220 psig. Operating pressure 150 psig. Body is made from aluminum die cast. Can be used with any non-flammable, non-toxic, non-corrosive gasses except oxygen.

An ideal manual directional control valve for use with all pneumatic systems. Precision lapped rotor and seals offers high tolerance to dirt contamination. Offered as four-way, these valves may be used as two or three-way by plugging unused ports. (Note: "In" port must be used as pressure inlet port to assure efficient operation). Max supply pressure 220 psig. Operating pressure 150 psig. Body is made from aluminum die cast. Can be used with any non-flammable, non-toxic, non-corrosive gasses except oxygen.